特点：

1.   采用开边式，适合较大裁片及鞋面内衬及补强片贴合
   
2. 安装有冷却风管，可在高温关机情况下，自动散热，直至低于75℃自动停机
   
3. 皮带采用无接缝铁氟龙运输带，采用有特殊构造装置，可自动排除皮带偏离，确保皮带使用寿命更长
   
4. 上下层皮带装有清洁刮片，能及时清理杂物，使贴合效果更佳
   
5. 加热方面采用前后分开控制温控，同时装有固态继电器，使温度更准确
   
6. 贴合宽度为460mm，输送长度为1500mm，加热空间为780mm，以1500*100mm材料计算每分钟可压100片材料，根据不同材料可调节快慢
   
7. 压力方面采用气压式加压，根据不同材料可调气压阀来控制压力大小
   
8. 作业使用连续式无接缝铁氟龙输送带，更能提高生产效率
   

Features:

1. Adopting an open edge design, suitable for fitting larger cuts, shoe lining, and reinforcement pieces
   
2. Equipped with a cooling air duct, it can automatically dissipate heat during high-temperature shutdown until it reaches below 75 ℃ and automatically shuts down
   
3. The belt adopts seamless Teflon transport belt with special construction device, which can automatically eliminate belt deviation and ensure a longer service life of the belt
   
4. The upper and lower belts are equipped with cleaning blades, which can timely clean debris and improve the bonding effect
   
5. In terms of heating, separate front and rear temperature control is used, and a solid-state relay is installed to make the temperature more accurate
   
6. The bonding width is 460mm, the conveying length is 1500mm, and the heating space is 780mm. Based on the calculation of 1500 * 100mm material, it can press 100 pieces of material per minute, and the speed can be adjusted according to different materials
   
7. In terms of pressure, pneumatic pressure is used, and the pressure can be controlled by adjusting the pneumatic valve according to different materials
   
8. The use of continuous seamless Teflon conveyor belts for operations can improve production efficiency