机器特性：

1. 本机无需使用压低模，节省生产成本
   
2. 一机两用，可以做鞋成型及组底加工
   
3. 操作简单快捷，操作人员容易上手
   
4. 机构简单稳固，维修容易，相比传统机型改进了因为长时间使用导致的歪斜
   
5. 可依鞋型调整加压速度
   
6. 水袋可放置空间尺寸为395*160*230mm。可压制范围大，小尺码童鞋可一次一双
   
7. 水袋耐用度更高，测试数据12秒在实验室下可重复压合20万次以上
   
8. 标配红外线光感测器，急停装置，机械防护部分严格按照CE规范标准，操作安全
   
9. 设备创新使用全伺服螺杆式系统控制液压缸活塞，使液压缸活塞快速精准推动水溶性抗燃液压油到压缸内形成***的压力介质，无死角的传导压力，保证压力精准稳定，可减少边墙老鼠洞的产生或边角脱胶的现象
   
10. 本机采用伺服系统，相较旧型无模压底机，无传统油泵可直接杜绝油耗的挥发。有加压才有能耗，待机时不会耗电。噪音小，动态作业下音量约为80dB
    
11. 本机采用伺服系统，使整套系统大大减少日常保养与维修率，日常维修维护成本低
    
12. 本机设计无需另外加油，到工厂后直接通电即可使用
    

Machine characteristics:

1. This machine does not require the use of low pressure molds, saving production costs
   
2. One machine dual-use, capable of shoe molding and sole assembly processing
   
3. Simple and fast operation, easy for operators to get started
   
4. The mechanism is simple and stable, easy to maintain, and has improved the skewness caused by long-term use compared to traditional models
   
5. Adjust the pressure speed according to the shoe type
   
6. The space size for placing water bags is 395 * 160 * 230mm. Large compression range, small size children's shoes can be worn one pair at a time
   
7. The water bag has higher durability, and the test data can be repeatedly pressed more than 200000 times in the laboratory within 12 seconds
   
8. Standard infrared light sensor, emergency stop device, mechanical protection strictly in accordance with CE standards, ensuring safe operation
   
9. Innovative equipment uses a fully servo screw system to control the hydraulic cylinder piston, allowing the hydraulic cylinder piston to quickly and accurately push water-soluble fire-resistant hydraulic oil into the pressure cylinder to form a comprehensive pressure medium without dead corners, ensuring accurate and stable pressure and reducing the occurrence of side wall mouse holes or corner debonding
   
10. This machine adopts a servo system, which can directly eliminate the volatilization of fuel consumption without traditional oil pump compared to the old type of non molded bottom machine. Only with pressure can there be energy consumption, and there will be no power consumption during standby. Low noise, the volume is about 80dB under dynamic operation
    
11. This machine adopts a servo system, which greatly reduces the daily maintenance and repair rate of the entire system, and the cost of daily maintenance is low
    
12. The design of this machine does not require additional refueling, and can be used directly after being powered on at the factory